TA的每日心情 | 衰 2014-1-3 11:31 |
---|
签到天数: 2 天 [LV.1]初来乍到
普通用户
|
发表于 2013-4-1 08:58:44
|
显示全部楼层
本帖最后由 会修电脑的人 于 2013-4-1 09:16 编辑
georgefan101 发表于 2013-3-31 12:36
Q1
问题出在网卡上。
4.1支持的网卡多。
通过翻字典理解外国人的教程,发现问题所在,已经解决了,谢谢哈
The How-To(for REAL Hardware):
1. Extract 'DS3612xs_2668_4.1%2B%2B.7z' using 7-zip. You'll have three files.
-DSM_DS3612xs_2668.pat, DSM installation file
-SynoBoot_3612xs_4.1++.img , bootloader image (needed if youll be testing on REAL hardware)
-SynoBoot_3612xs_4.1++.vdi, VirtualBox virtual disk file(needed if youll be testing on VM )
2. Extract 'win32diskimager-binary06.rar'. Insert your USB flash drive and launch W32DiskImager.
-Load the .IMG file from STEP1 and choose your USB drive from the drop down list.
-Click Write and WAIT for complete.
Pre-Prep your PC:
-Set BIOS to boot from USB
-WIPE SATA disk youll be using, then connect to 'SATA_0' port on your motherboard
-Connect to network switch(DHCP Required)
3. Insert USB into PC and power it ON. If you have a console(KVM) attached to the PC youll see machine coming up.
4. Launch Synology Assistant from your Windows workstation and click 'Search'. If you've done everything correctly you'll see a new 'DiskStation' has been found.
-- IMPORTANT -- Disconnect the USB flash drive from the computer for this next step.
5. Right-click the new 'DiskStation' and choose 'Install'. Browse and select the 'DSM_DS3612xs_2668.pat' file. Choose a Name for the DiskStation, a new default admin password and IP configuration. After installation is complete the DiskStation will reboot automatically. Power it OFF manually now.
-- INSERT USB Flash drive back into PC --
6. Power on PC. DSM will boot normally. Back to Synology Assistant click 'Search' again. Depending on the name and network config you chose during installation you will see now see a DiskStation has been found with the NAME you chose. The previous Installation Progress bar will show 100% complete and you can now access your DiskStation by opening a browser and pointing to the IP its configured with.
|
|